Applying Power - DigiTech RP500 Owner's Manual

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this should be set to 5 on EQ's to obtain the amp's natural
voicing.). Then follow the steps listed below.
. Turn the amp volume all the way down.
2. Connect the plug of the PS093B power supply to the power jack on the rear panel of the
RP500.
3. Connect the other end of the PS093B power supply to an AC outlet. Turn the RP500's Mas-
ter Level knob (Knob 6) down to "0".
4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal
playing level.
5. Gradually increase the RP500's Master Level knob to achieve the desired volume.
4. Turn amp volume up
1. Turn amp volume down
0
2. Connect PS0913B to power jack
5. Turn the RP500's Master Level
to the desired listening volume
3. Connect PS0913B
to AC outlet and
turn the RP500's
Master Level to "0"