Harmony; Dual Delay - DigiTech RP 3 User Manual

RP-3
H1-H6 (Harmony)
Values
Type
Amount
Key/Bend
The RP-3 also offers Intelligent Harmony Pitch Shifting that lets you select the key, scale and amount of shifting in the signal. The
parameters are as follows:
Type
Amount
Key/Bend
Note: The reverb and Wah effects are not available when the Harmony effect is selected. For complete reference guide to these
scales, please refer to the Harmony interval charts located in the Appendix section on page 18.
Delay
Parameters
On/Off
Type
Level
Delay Time
Feedback
Delay Parameters are as follows:
Delay
Type
Level
Delay Time
Feedback
User Guide
Displayed Values
H 1 . . H 6
O d . . . O u
a b . . . G #
This parameter lets you select the scale that the Harmony effect uses. There are six different scales and
they are numbered as follows: H1- Major, H2- Minor, H3 - Harmonic Minor, H4 - Dorian, H5 -
Mixolydian, and H6 - Blues.
Amount lets you select how much the pitch is shifted. This Ranges from: Octave down-Octave Up
This parameter lets you select which key the harmony shifting takes place in. This ranges from: A
Displayed Values
O n - B y
1 . . . 2
0 . . . 9 9
1 . . . 3 5
.
0 . . . 9 9 . . . r h
Turns the Delay on and off.
Determines the type of delay. Type 1 is a mono delay and Type 2 is a ping pong delay.
Controls the level of the delay. 2. Ranges from 0 to 99.
The available delay time ranges are 1 (no delay) to 3.5 seconds.
The number of delay repeats. Ranges from 0 to 99 and rh (repeat/hold).
Section - 4 Effects and Parameters
to G.
15