Flexible Output Mode
TM
The Red Special Pedal has three Flexible Output Modes
Mixer and Stereo Amp. These modes let you send a mono signal to an
amp or mixer, or a stereo signal to two amps or two channels of a mixer.
Mode 1 (MONO) is the default output mode when one cord is plugged
into either the OUT 1 (AMP) or OUT 2 (MIXER) output.
Mode 2 (STEREO MIXER) and Mode 3 (STEREO AMP) are enabled when
two cords are plugged into both the OUT 1 (AMP) and OUT 2 (MIXER)
outputs. Mode 2 (STEREO MIXER) is the default stereo output mode
selected from the factory. Mode 3 (STEREO AMP) is enabled by selecting
STEREO AMP mode via the Flexible Output Mode Setup. Once Mode 3 is
selected, you can return to Mode 2 (STEREO MIXER) using the Flexible
Output Mode Setup.
Please refer to the Flexible Output Mode Setup section for more
information.
Flexible Output Mode
: Mono, Stereo
TM
1. Power up the Red Special Pedal.
2. Select Model 7 using the MODEL knob.
3. Press and hold the HEEL SWITCH for three seconds. The
4. Release the HEEL SWITCH.
5. Turn the MODEL knob to Model 6 to select STEREO AMP mode,
6. Press the TOE SWITCH to exit Flexible Ouput Mode Setup; the
NOTE: Keeping the MODEL knob set to Model 7 will leave the pedal in
STEREO MIXER mode (Flexible Output Mode 2). Selecting any other
Models besides 6 or 7 will prevent you from exiting Flexible Output
Mode Setup.
Setup
TM
INDICATOR LED begins to flash yellow.
or leave the MODEL knob at Model 7 to select STEREO MIXER
mode.
INDICATOR LED turns off.