Use Your Tv; Switching On Your Tv And Putting It In Standby Mode; Adjusting Volume; Switching Channels - Magnavox 19ME402V Owner's Manual

4 Use your TV
Switching on your TV and putting it in standby
mode
To Turn Power On or to Turn Standby On
• Touch or press . on the front panel or the remote control.
Note
•
Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
Adjusting volume
•
The above image is an example for 32 inch and larger screen size TVs.
It may differ depending on what product you purchased.
To increase or decrease volume
• Touch VOL ◄(down) / ►(up) on the front panel or press
VOL + / − on the remote control.
To mute or unmute sound
• Press on the remote control to mute the sound.
again or VOL + / − to recover the original sound.
• Press
Switching channels
•
The above image is an example for 32 inch and larger screen size TVs.
It may differ depending on what product you purchased.
To select Channels by using CH ▲/▼ or CH + / −
• Touch CH ▲(up) / ▼(down) on the front panel or press CH + / −
on the remote control.
To select Channels by using the NUMBER buttons
DigitalTVoperation
• For Digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Analog/CableTVoperation
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note
•
To select the non-memorized channels, use the NUMBER buttons.
•
N o Signal will appear on the TV screen after the subchannel broadcast is over.
•
Audio only program message will appear on the TV screen, when you receive only
sound signal.
13
English