Installing A 2.4-Ghz Radio - Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Hardware Installation Manual

Chapter 4 Upgrading the 2.4-GHz Radio

Installing a 2.4-GHz Radio

To install a new 2.4-GHz radio card into the access point, follow these steps:
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Carefully remove the Cisco Aironet 2.4-GHz radio card from its anti-static bag.
Step 1
Grasp the radio card only on the edges, being careful not to touch components on the board or the gold
Step 2
connector pins.
Step 3 Connect the black antenna wire connector to the radio card antenna connector marked by the black label
(see
To avoid damaging the antenna wire assemblies, handle them by their connectors.
Caution
Figure 4-4
1
2
Connect the white antenna wire connector to the radio card antenna connector marked by the white label
Step 4
(see
OL-8370-04
Figure 4-4).
Antenna Connector Labels and Mini-PCI Connector
Antenna connector (black wire)
Antenna connector (white wire)
Figure 4-4).
1
2
3
3 Mini-PCI connector
Cisco Aironet 1200 Series Access Point Hardware Installation Guide

Installing a 2.4-GHz Radio

4-7