Removing A 2.4-Ghz Radio - Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual

Chapter 5 2.4-GHz Radio Upgrade
Step 3 Remove the antenna wires from the blank spacer card.
Caution
Step 4 Remove the blank spacer card from the mini-PCI connector.
For instructions on installing the radio card, go to the

Removing a 2.4-GHz Radio

To remove a 2.4-GHz radio card from your access point, follow the steps below:
The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
Caution
handling.
Use your fingers to carefully remove the antenna wire connectors from the 2.4-GHz radio card.
Step 1
Caution
Caution
OL-2155-02
To avoid damaging the antenna wire assemblies, handle them by their connectors.
The antenna connectors can be damaged by using a pair of long-nose pliers during the removal
process.
To avoid damaging the antenna wire assemblies, handle them by their connectors.
"Installing a 2.4-GHz Radio"
Cisco Aironet 1200 Series Access Point Hardware Installation Guide

Removing a 2.4-GHz Radio

section.
5-5