FUTABA FP-8SSAP Instruction Manual page 10

32 Transmitter RF module
• Change this module when switching frequen-
cy bands (50, 53, 72, and 75MHz).
While pushing this tab to the
inside, pull the RF module
forward.
Transmitter crystal
8
38 Trimmer Panel
•This panel contains switches, buttons, and trimmers for setting and adjusting the many versatile
transmitter functions. Use the small screwdriver supplied with the set for making adjustments.
Use the transmitter with fail-safe switches [7], [10], [29], [31], [32], and [33] in the INHIB (function off)
position until you become familiar with the set.
39 Trainer cord socket
34 Snap roll direction switch (R/L)
35 Snap roll direction switch (UP/DOWN)
•These switches control the direction of the
snap roll when the Snap roll switch 13 is used.
A temperature rise
36 Fail safe set button
at the RF module
• This pushbutton is used when setting the Fail
section during use
is normal. Safe servo positions (FS instructions Page 24).
37 Back Cover
• Removal of this cover exposes the trimmer
panel. Remove as shown in Fig. 3.
Fig. 2
Remove the back cover by pulling
these stoppers in the arrow direc-
tion.
Fig. 3
Fig. 4