Tx&Rx Data Screen - FUTABA CDR5000 Instruction Manual

2. TX & RX DATA Screen
[TX&RX DATA --]
TX&RX DATA 01 though 10 represent the data used for TX&RX port. (*TX&RX DATA: The content
displayed on the screen differs from 01 and the others, which are 02 through 10.) "01" represents the
current cycle. "02" represents the previous cycle. "03" represents the two previous cycle. And so on. If
the cycle mode has been carried out at the latest, the charge and discharge data of the last cycle will be
shown in the "TX&RX DATA 01". And the data of the previous cycle will be shown in the "TX&RX
DATA 02".
<How to operate>
Operate " " and " " keys to get the DATA number.
[Contents of TX&RX DAT01]
MODE
This indicates the condition of a battery that is to be charged or discharged.
NO BAT: No battery is connected.
READY: A battery is connected. Ready to start charging or discharging.
CHG: The battery is now under charging.
D-CHG: The battery is now under discharging.
CYCLE01-99: Cycle charging/discharging is now under operation.
SHORT: This includes reverse connection of a battery, electrical short, over-discharge and electrical short at TX&RX
port of CDR-5000.
LOW BAT: when the output voltage of a power source drops while charging.
VOLT.
This shows the voltage of the battery that is currently connected. In the discharge mode, it shows the
voltage at the end of a discharging event.
AMPE.
This shows the present charging current or discharging current. Minus symbol "-" will be attached to
the number in case of discharging mode.
32