Compulsively End Of Charging/Discharging - FUTABA CDR5000 Instruction Manual

6. Compulsively End of Charging/Discharging

[How to stop charging on the way at DX]
Push any one of the keys of "DX CHG", "DX D-CHG" and "DX CYCLE" in order to intentionally
stop charging on the way at DX. Then the MODE indicator changes from "CHG" to "READY" and
the red LED of "DX Charging" turns off with a single beep.
*If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
[How to stop discharging on the way at DX]
Push any one of the keys of "DX CHG", "DX D-CHG" and "DX CYCLE" in order to intentionally
stop discharging on the way at DX. Then the MODE indicator changes from "D-CHG." to "READY"
and the blue LED of "DX Discharging" turns off with a single beep.
*If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
[How to stop cycle charging/discharging on the way at DX]
Push any key of "DX CHG", "DX D-CHG" and "DX CYCLE" in order to intentionally stop charging
or discharging on the way at DX. Then the MODE indicator changes from "CHG" or "D-CHG." to
"READY" and either of the red LED of "DX Charging" or the blue LED of "DX Discharging" turns
off with a single beep.
*If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
[How to stop charging on the way at TX/RX]
Push any key of "TX&RX CHG", "TX&RX D-CHG" and "TX&RX CYCLE" in order to intentionally
stop charging on the way at TX&RX. Then the MODE indicator changes from "CHG" to "READY"
and the red LED of "TX/RX Charging" turns off with a single beep.
*If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
[How to stop discharging on the way at TX/RX]
Push any one of the keys of "TX&RX CHG", "TX&RX D-CHG" and "TX&RX CYCLE" in order to
intentionally stop discharging on the way at TX&RX. Then the MODE indicator changes from "D-
CHG." to "READY" and the blue LED of "TX/RX Discharging" turns off with a single beep.
* If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
[How to stop cycle charging/discharging on the way at TX&RX]
Push any key of "TX&RX CHG", "TX&RX D-CHG" and "TX&RX CYCLE" in order to intentionally
stop charging on the way at TX&RX. Then the MODE indicator changes from "CHG" or "D-
CHG." to "READY" and either of the red LED of "TX/RX Charging" or the blue LED of "TX/RX
Discharging" turns off with a single beep.
* If the "BUZZER" is set to "OFF" in the "INITIAL SETTING", there will be no alarm buzzer.
Caution: Even if charging or discharging is stopped at DX and TX/RX, "STAND-BY"
mode is still effective until the battery will be disconnected. If you restart charging or
discharging from that status as it is, CDR-5000 will start operation based on that data.
However, if the operation is stopped in Cycle mode, CDR-5000 restarts from CYCLE01.
Disconnecting a battery will end the measurement of data.
26