How To Link Transmitter And Receiver - FUTABA 3PL-2.4G Instruction Manual

How to link the transmitter and the receiver
Each transmitter has an individually assigned, unique ID code. In order to start operation,
the receiver must be linked with the ID code of the transmitter with which it is being
paired. Once the link is made, the ID code is stored in the receiver and no further linking
is necessary unless the receiver needs to be used with another transmitter. (For T/R set,
the link is already done at factory.)
Link procedure
1 Bring the transmitter and the receiver close
to each other, within one meter.
2 Turn on the transmitter and the receiver.
3 Push and hold the Link Switch of the
receiver.
4 When the link is complete, the LED in the
receiver changes to solid green.
*Please refer the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Receiving signals, but ID is unmatched.
Assembly / Adjustment
14
Link Switch
Red : On
Green: On
Green: Blink
LED