Chapter 6. RF Link Test
6.2.1 Low and Zero RSSI Readings
For RSSI values less than 3, the Connection Quality Test screen displays underscores ( _ ) instead
of bars. In addition, the screen displays the letter X to indicate that a reply is not being received
from the remote access point within the one-second interval. In this case, RSSI is zero. If the letter
X is continuously displayed, the access points may be either out of radio range or their wireless
access point link is broken. For information on verifying the wireless access point operation, refer
to 6.3: Preparing for the RF Link Test. Figure 6-3 is an example of a screen showing the X's and
underscores.
Local Access Point
Remote Device MAC Address:
max |
Signal
Quality
min | x x x x _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Figure 6-3: Connection Quality Test Screen Showing Low RSSI
24
Connection Quality Test
00:A0:F8:94:C2:04
|
|
|
|
|
|
|
|
-------------------------------------------
Tx Rate
1 Mb/s
Rx Rate
1 Mb/s
Exit-[ESC]
Configuring Access Point Bridging and Repeating (WLAP Mode)
Tx Retries 13
RSSI
2