Chapter 5. Bridging Two Ethernet Networks
FRAME
Figure 5-4: Special Network Using Timeout Settings 2 & 3
5.2.1 Ethernet Timeouts and Access Point Settings
This section describes the Ethernet Timeout settings and other access point settings for the special
network in Figure 5-4. Ethernet Timeout settings, seen on the System Configuration screen,
include:
Setting
Timeout = 0
Timeout = 1
Timeout = 2
18
D
Timeout = 0
10BaseT Cross-Over
Cables (Figure 5-5)
C
Timeout = 3
B
Timeout = 2
A
Timeout = 1
Ethernet
Description
Ethernet Timeout function is disabled.
Access point detects a broken Ethernet connection and then turns
off its radio.. The Wireless LAN Activity indicator turns off.
When the Ethernet connection is restored, the radio is turned on
again.
Access point sends WLAP-Alive BPDU messages on the
Ethernet line as well as over wireless network. This allows other
access points on the same Ethernet line to detect its presence.
Configuring Access Point Bridging and Repeating (WLAP Mode)
Mobile unit roams to access
point H if access point A loses
Ethernet connection.
H
Timeout = 0
G
Timeout = 3
F
Timeout = 2
E
Timeout = 1