Before You Begin; Unpacking Your Player; Power Supply; Installing Batteries - RCA RP5050 - Digital 128 MB Built Manual De L'utilisateur

RP5050 EN 18/10/06

Before You Begin

Unpacking your Player

• one voice recorder
• one USB dock
• two NiMH rechargeable "AAA"
batteries
• one carrying case
• one clip-on mic

Power Supply

This player can be operated by two
NiMH "AAA" batteries (included).
Installing Batteries (Included)
1. Slide the battery compartment
door to the bottom and lift up the
door to open.
2. Insert the two supplied NiMH
rechargeable "AAA" batteries
with polarities matching
indications.
3. Replace the battery compartment
door.
4. Refer to the battery level indicator
( ) on display for batteries level.
When the indicator is empty,
follow the steps below to recharge
the batteries.

Recharging Batteries

1. Ensure the two supplied NiMH
rechargeable "AAA" batteries are
installed correctly and the player is
off.
11:16 AM Page 8
2. Connect the USB dock to the
computer. Then connect your
player to the USB dock.
3. Recharging begins automatically.
It should take about 6 hours to
fully recharge 650mAh NiMH
batteries.
!
rechargeable "AAA" batteries other than
those supplied. If power interruption
exceeds 20 seconds, you will have to reset
the date and time.
Note:
This player can only recharge NiMH
battery.

Using Headphones and External

Microphone

• When headphones are connected,
the sound output from speaker
will be cut.
• When external microphone is
connected, no record can be made
from the built-in microphone.
Switching On and Off the Player
• Press
start playback. The player will
enter Function Menu.
• Press and hold
player completely.
Warning:
You may have to replace the
batteries if you are using non-
to turn on the player to
to turn off the
EN
4