Overview; Logging Into The Cisco Unified Cm Administrator - Cisco CTS-500 Configuration Manual

Overview

Overview
The CTS relies on the Cisco Unified CM configuration to tell the CTS what hardware is present. The
CTS software finds the configured hardware or reports an error if the configured hardware is not found.
•
•

Logging into the Cisco Unified CM Administrator

To log into the Cisco Unified CM Administration interface, follow these steps:
Step 1 Open a web browser.
Note The Cisco Unified CM Administration program operates on the Microsoft Internet Explorer version 6 or
a later version.
Step 2 Access a web server that is supported by the Cisco Unified CM Administration interface from any user
PC in your network.
Step 3 In the address bar of the web browser, enter the following URL:
Where CCM-server-name is the name or IP address of the server.
Note You may need to specify the address of the server where Cisco Unified CM is installed. If your network
uses DNS services, you can specify the hostname of the server. If your network does not use DNS
services, you must specify the IP address of the server.
Log in with your assigned administrative privileges.
Step 4
Select Cisco Unified Communications Manager Administration in the Navigation field at the upper
Step 5
right corner of the page and click Go to return to the Cisco Unified CM Administration home page.
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-2
Chapter 1
To apply any changes made on the Cisco Unified CM device page, simply click Restart. This
enables the updated configuration to be read, applied to the CTS, and Calling Service is restarted.
Alternately you can click Reset, which causes the CTS to reboot. On startup, the CTS reads the
Cisco Unified CM configuration and applies any changes.
https:// CCM-server-name
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
OL-21851-01