Maintenance; Nozzle; Brushes - Hoover FH50210 Owner's Manual

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.

nozzle:

how to Clean
If lint or other debris becomes lodged in nozzle, it
can be removed for cleaning.
Turn off and unplug cleaner from electrical outlet.
Remove both tanks as described in Figs. 2.8 and
2.13. With handle in upright position, tilt cleaner
back so that handle rests on the floor.
5.1 Pull tab (A) at rear edge of nozzle and pull
forward to remove and clean nozzle.
5.2 To replace nozzle, line up tabs (B) on nozzle
with holes (C) in cleaner. Slide tabs into holes.
Push nozzle completely onto cleaner. Press down
on nozzle to engage rear tab.
Replace Dirty Water Tank.
The nozzle must be in the proper position in order
for the Dirty Water Tank to go on properly.

brushes:

how to Change and Clean
Your cleaner is equipped with removable brushes.
Follow these directions for changing brush
assemblies or for easy cleaning.
CAUTION
!
To reduce the risk of injury from moving parts,
unplug cleaner before servicing.
how to remove
Turn off and unplug cleaner from electrical outlet.
To prevent possible leaking, remove Clean Water
Tank and Dirty Water Tank. Set tanks aside.
With handle in upright position, tilt cleaner back until
handle rests on the floor.
5.3 Grab brush assembly and pull firmly.
The brushes can be cleaned under running water.
how to replace
5.4 Align posts (A) on both ends of brush assembly
with slots (B) in cleaner housing.
Make sure that the hexagonal post (C) also aligns
with the hole (D). Turn brushes slightly until post fits
easily into hole.
Press brush assembly firmly to snap into place.

5. MaintenanCe

5.1
5.3
!
5.4
15
A
b
A
C
Actual model may vary from images shown.
5.2
C
b
D
b
A