(servicing) instructions in the literature accompanying the appliance. to rain or moisture. Le point d'exclamation à l'intérieur d'un triangle équilatéral est employé pour alerter les utilisateurs de la présence d'instructions importantes pour le fonctionnement et l'entretien (service) dans le livret d'instruction accompagnant l'appareil. FRS SERIES AMPLIFIERS...
AC POWER REQUIREMENTS ......11 THERMAL CONSIDERATIONS ......11 RACK MOUNTING .......... 11 MAINTENANCE ..........11 Need help with your new FRS amplifier? • Visit www.mackie.com and click Support to find: FAQs, manuals, addendums, and user forums. • Email us at: techmail@mackie.com.
Fast Recovery circuitry for clean, undistorted make the technical writer feel loved. sound — even at clipping The FRS series amplifiers are designed for continu- • Ultra-light switching power supply for maxi- ous duty in speech, music, and sound reinforcement...
Getting Started • The binding post connectors are wired as fol- The following steps will help you set up your lows: amplifier, and get the levels just right. Red = hot (+ speaker terminal) Settings: Black = cold (– speaker terminal) •...
4 ohms: Keep these ventilation slots free from any obstruc- tions, so the air may flow freely and cool down the power FRS•1300 = 420 watts per channel into 4 ohm transistors. FRS•1700 = 540 watts per channel into 4 ohms FRS•2800 = 850 watts per channel into 4 ohms...
The FRS amplifiers are designed to be mounted in a material. Under typical conditions reproducing rock standard 19 inch rack. They require two rack spaces music where musical peaks are just below clipping, the (2U = 3.5").
Appendix A: Service Information the amplifier. The SIG LEDs should be blinking If you think your Mackie product has a problem, to indicate that signal is present. please check out the following troubleshooting tips and do your best to confirm the problem. Visit the Support •...
“Support” and select “Locate a Service Center.” Service for Mackie products living outside the United States can • Try switching sides: Turn off the amp, swap the be obtained through local dealers or distributors.
Ring = Cold (–) are “up to” lengths. For in-between lengths, use the next larger conductor gauge. Using larger than the recommend- ed conductor size is always permissible. Using smaller than recommended conductor size will result in higher power losses. FRS SERIES AMPLIFIERS...
Parallel The recommended conductor gauges are listed for AWG (American Wire Gauge) and Metric WG (Metric Wire Gauge). Note that smaller AWG numbers = larger “Parallel” means that the positive amp output con- conductors and smaller Metric WG numbers = smaller nects to the positive terminals of all the speakers, conductors.
Maximum Input Level without notice. 9.75 Vrms (+22 dBu) “Mackie,” and the “Running Man” are registered trademarks of LOUD Technologies Inc. All other brand names mentioned are Turn On Delay trademarks or registered trademarks of their respective hold- 2.5 seconds...
For more information about where you can drop off your waste equipment for recycling, please contact your local city office, waste authority, or your household waste disposal service. FRS SERIES AMPLIFIERS...
Products repaired the authorized Mackie dealer where you purchased the product. under warranty will be returned freight prepaid by LOUD It is necessary to establish purchase date and determine whether Technologies to any location within the boundaries of the USA your Mackie product is within the warranty period.
Page 20
16220 Wood-Red Road NE • Woodinville, WA 98072 • USA United States and Canada: 800.898.3211 Europe, Asia, Central and South America: 425.487.4333 Middle East and Africa: 31.20.654.4000 Fax: 425.487.4337 • www.mackie.com E-mail: sales@mackie.com...