Craftsman 21221 - 12 in. Sliding Dual Bevel Compound Miter Saw Operator's Manual page 80

the laser element where you can
position an adjustable wrench for
your adjustment.
C. Aligning The Laser Beam
1. Loosen only 1/2 turn at a time the
four set screws (1).
2. Adjust laser by turning the left side
set screws clockwise to shift the
laser line to the right. To shift the
laser line to the left, turn the right
side set screws 1/2 turn at a time.
3. Once alignment of the laser is
achieved, tighten only 1/2 turn at a
time the four set screws (1).
Fig. 0
Fig. P
THE UPFRONT SUPPORTS
ADJUSTMENT (FIG. Q, R)
Wide pieces need upfront supports (1).
1. Rotate the two upfront supports (1)
toward the rear of the saw.
Laser Switch
i ...... l
Left Side View Right Side View
Fig. Q
\
1
NOTE: These supports (1) should be
placed into the 0 position as shown in
Fig. R before transporting.
Fig. R
1
24