Hard Drive Installation Guidelines; Using The Cable-Select Feature With Ultra Ata Devices - Compaq 239158-999 - Mini Tower - Power Supply 250 Watt Hardware Reference Manual

Using the Cable-Select Feature with Ultra ATA Devices

Hardware Reference Guide

Hard Drive Installation Guidelines

Optional drives are available from Compaq in kits that include a
special drive cable. The configuration of the drive employs a cable-
select feature that identifies the drive as device 0 (primary drive) or
device 1 (secondary drive).
Device 1 is the drive connected to the cable's middle connector.
Device 0 is the drive connected to the cable's end connector (applies
only to 80-conductor ATA cables). See "Guidelines for Installing
Ultra ATA Devices" in this appendix for an example of an Ultra
ATA cable.
Compaq hard drives ship with jumpers preset to cable-select mode;
therefore, no jumper setting changes on the existing or optional
drives are required. If you purchase a third-party hard drive, refer to
the documentation included with the kit to ensure proper installation
and configuration of cables.
If installing a second device on the primary controller, you must use
an 80-conductor Ultra ATA cable for optimal performance. This
cable is standard on select models.
B
B-1