Setting Up The Sensor For Triggering - Texas Instruments TI-Nspire Manual Book

Setting the delay at zero allows you to use the manual trigger button
on the Lab Cradle to start the collection. See Using the Manual
Trigger to Start the Collection.
6. Click .
OK
The Remote Setup dialog box opens.
A message is displayed telling you how to start the collection and that
it is safe to disconnect the data collection device.
7. Disconnect the sensor.
8. View the LED lights to determine if the sensor is ready to collect data.
• Red. Indicates that the system is not ready.
• Amber. Indicates the system is ready, but is not collecting data.
• Green. Indicates the system is collecting data.
9. Press the trigger to collect data.

Setting Up the Sensor for Triggering

To start data collection based on a specific sensor reading, the TI-Nspire™
Lab Cradle and sensor must be connected.
You must set the sensor and the threshold type for the system to use
when collecting data. When the trigger is reached, the sensor starts
collecting data.
To set up the trigger:
1. Connect the sensor.
2. Click
Experiment > Advanced Set up > Triggering > Set Up
The Configure Trigger dialog box opens.
Using Advanced Data Collection Options
.
65