Start-Up Guide; Checking The Accessories; Inserting Batteries Into The Remote; 1: Attaching The Stand - Sony KLV-26S400A - 26" Multi-System HDTV LCD TV Operating Instructions Manual

Start-up Guide

Checking the
accessories
AC power cord* (KLV-40S400A only)
Stand (1) and screws (3)
Remote RM-GA011 (1)
Size AA batteries (R6 type) (2)
* For models with ferrite cores, do not remove these cores.
Inserting batteries into
the remote
Push and lift the cover to open.
~
• Observe the correct polarity when inserting batteries.
• Do not use different types of batteries together or mix
old and new batteries.
• Dispose of batteries in an environmentally friendly
way. Certain regions may regulate the disposal of
batteries. Please consult your local authority.
• Handle the remote with care. Do not drop or step on
it, or spill liquid of any kind onto it.
• Do not place the remote in a location near a heat
source, a place subject to direct sunlight, or a damp
room.
4
GB

1: Attaching the stand

1
Place the TV onto the stand by aligning the
screw hole alignment lines over the stand
as shown.
2
Fix the TV to the stand according to the
arrow marks that guide the screw holes
using the supplied screws.
~
• This TV is very heavy, so two or more people should
place the TV on the stand.
• If using an electric screwdriver, set the tightening
torque at approximately 1.5N·m (15kgf·cm).
• When installing the TV onto the wall, follow step 1 to
prevent the TV panel from falling over.
• Ensure the AC power cord is away from screw holes
during stand installation to avoid damage to the AC
power cord (KLV-37S400A/KLV-32S400A/KLV-
26S400A only).