Set-Up Menu - Sony KLV-26S400A - 26" Multi-System HDTV LCD TV Operating Instructions Manual

Display Area
(KLV-40S400A only)
Horizontal Shift
Vertical Shift
Vertical Size

Set-up menu

Press MENU and select "Settings". Press
Auto Start-up
Language
Cinema Drive
AV Set-up
26
GB
Adjusts the screen area for displaying the picture.
"Full Pixel": Displays the picture for 1080/50i, 1080/60i, 1080/50p and 1080/60p
sources (HDMI or component input only) or 1080/24p sources (HDMI input only)
in the original size when parts of the picture are cut off.
"Normal": Displays the recommended picture area.
~ • "Display Area" is available only when "Wide Mode" is set to "Full".
Adjusts the horizontal position of the picture.
Adjusts the vertical position of the picture when "Wide Mode" is set to "Wide
Zoom" or "Zoom".
Adjusts the vertical size of the picture when "Wide Mode" is set to "Wide Zoom" or
"Zoom".
F/f
to select the "Set-up" icon (
Starts the initial set-up procedure.
Usually, you do not need to do this operation because it was done when the TV was
first installed (page 6).
However, this option allows you to repeat the process (e.g. to retune the TV after
moving house, or to search for new channels that have been launched by
broadcasters).
Selects the language in which the menus are displayed.
Provides smoother picture movement when playing DVD or VCR images taken on
film, reducing picture blur and graininess.
"Auto": Provides smoother picture movement than the original film video. Use this
setting for standard use.
"Off": Turns off the "Cinema Drive" feature.
~ • If the image contains irregular signals or too much noise, "Cinema Drive" will be
automatically turned off even if "Auto" is selected.
• "Cinema Drive" is not available for a PC input source.
Video Labels
Assigns a name to any equipment connected to the side and rear jacks. The name will
be displayed briefly on the screen when the equipment is selected. You can skip input
signals from connected equipment that you do not want displayed on the screen.
F f
1 Press
/ to select the desired input source, then press
F f
2 Press
/ to select the desired option below, then press
Equipment labels: Uses one of the preset labels to assign a name to connected
equipment.
"Edit:": Creates your own label. Follow steps 2 to 4 of "Programme Labels"
(page 30).
"Skip": Skips an unnecessary input source.
Auto S Video
Selects the input signal from S video jack
connected.
"On": Switches automatically between the S video jack and the composite video
jacks depending on the cable connection.
"Off": Activates the composite video jacks.
.
), then press
.
.
1 when / 1 jacks are both