Chevrolet TRACKER 2000 Manual page 118

3. Release the plastic strip sewn along the bottom
edge of the window by gently pulling down and out.
Then release the plastic along the front edge of the
window by pulling it forward and out. It may help to
rock the window back and forth to remove it.
4. Unfasten the plastic clip, which is part of the canvas
top, at the top front corner of each side window.
Then unzip the zipper the rest of the way and remove
the side window.
To install the side window:
Make sure the plastic clip at the top front corner of the
canvas top is unfastened. Then start by zipping the
zipper about 3 inches (8 cm), to hold the window in
place. When zipping, place the rear bottom corner of the
window inside the rear part of the vehicle body to help
support the window while you engage the zipper end.
Install the plastic strip into the window channel before
completely zipping the window. There is a locating pin
in the front upper corner to assist in aligning the window.
Pull rearward on the rear edge of the window to make
sure the window is secure and finish zipping the window.
2-53