Cisco ATA186-I1 Administrator's Manual page 92

Operational Parameters
Table 5-2 ConnectMode Parameter Bit Definitions (continued)
Bit Number Definition
13 0—Use G.711µ-law for fax pass-through codec.
1—Use G.711A-law for fax pass-through codec.
Default: 0
14-15 0—Use fax pass-through.
1—Use codec negotiation in sending fax.
2,3—Reserved.
Default: 0
16-20 Reserved.
21 0—Enable G729 on the Phone 1 FXS port.
1—Enable G729 on the Phone 2 FXS port.
Default: 0
22-24 Reserved.
25 0—Use the asterisk (*) as the first digit for your pre-call service access code.
1—Use the pound key (#) as the first digit for your pre-call service ccess code.
Default: 0
26 0—Enable the Auto Resume softkey when the Cisco ATA is in the call-waiting state.
1—Disable the Auto Resume softkey when the Cisco ATA is in the call waiting state.
Default: 0
27 0—Register the Cisco ATA as device type Cisco ATA 186 if you are running Cisco CallManager 3.2 or later.
This setting is the default.
1—Register the Cisco ATA as device type Cisco 7960 if you are running Cisco CallManager versions 3.0 or
3.1
Default: 0
28-29 0—Select the Cisco ATA Style for mid-call services. Services are call hold/resume, call transfer and
conference call.
1—Select the Bellcore Style for mid-call services. Services are call transfer and conference call.
2—Select the Cisco VG248 Style for mid-call services. Services are three-way calling, call transfer and
conference call.
For end-user procedures of each service that the Cisco ATA supports for each style, see
to Use Pre-call and Mid-call Services."
Default: 0
30 0/1—Disable/enable Cisco IOS Telephony Solution (ITS). Cisco ITS runs on an IOS router and is a subset of
Cisco CallManager. If you have Cisco ITS, refer to the documentation for that product.
Default: 0
31 0 - Disable XML configuration file support (use if you are running Cisco CallManager version 3.0).
1 - Enable XML configuration file support (use if you are running Cisco CallManager version 3.1 or later).
Default: 1
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
5-22
Chapter 5 Parameters and Defaults
Appendix A, "How
OL-4652-01