Network Configuration Menu - Cisco 7937G - Unified IP Conference Station VoIP Phone Administration Manual

Chapter 4 Configuring Settings on the Conference Station
Table 4-2
Category
Security settings
Related Topics
•
•
•
•
•
•

Network Configuration Menu

The Network Configuration menu provides options for viewing and configuring a variety of network
settings.
For information about how to access the Network Configuration menu, see the
Configuration Menu" section on page
Before you can change an option on this menu, you must unlock options. See the
Locking Options" section on page 4-3
For information about the keys you can use to edit options, see the
Table 4-3 Network Configuration Menu Options
Option Description
DHCP Enabled Indicates whether DHCP is being
used by the conference station.
IP Address Internet Protocol (IP) address of
the conference station.
If you assign an IP address with
this option, you must also assign a
subnet mask and default router. See
the Subnet Mask and Default
Router options in this table.
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
Security Settings Configurable from the Conference Station
Description
Allow you to enable 802.1X
authentication
Displaying a Configuration Menu, page 4-2
Unlocking and Locking Options, page 4-3
Editing Values, page 4-3
Network Configuration Menu, page 4-5
Device Configuration Menu, page 4-8
Security Configuration Menu, page 4-12
Table 4-3 describes these options and, where applicable, explains how to change them.
Security Configuration Menu Option
802.1X Authentication
4-2.
for more information.
To Change
Unlock network configuration options. For more information,
1.
see the "Unlocking and Locking Options" section on page
Choose Applications > Settings > Network Configuration >
2.
DHCP Enabled.
3. Select Enabled to enable DHCP or Disabled to disable DHCP.
Press Select, and then press Save.
4.
Unlock network configuration options. For more information,
1.
see the "Unlocking and Locking Options" section on page
Set the DHCP Enabled option to No. For more information, see
2.
the DHCP Enabled option in this table.
Choose Applications > Settings > Network Configuration >
3.
IP Address.
4. Enter a new IP Address.
Press Validate, and then press Save.
5.
Network Configuration Menu
"Displaying a
"Unlocking and
"Editing Values" section on page 4-3.
4-3.
4-3.
4-5