Installing The Cisco Unified Ip Phone - Cisco 6941 - Unified IP Phone Slimline VoIP Administration Manual

Chapter
Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of
external devices, cables, and connectors. The system will perform adequately when suitable devices are
attached using good quality cables and connectors.
In European Union countries, use only external headsets that are fully compliant with the EMC Directive
Caution
[89/336/EC].

Installing the Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See
Figure 3-1
connections for a Cisco Unified IP Phone 6945, and
Unified IP Phone 6961.
Note Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before
using external devices, read the
performance information.
To install a Cisco Unified IP Phone, perform the tasks described in
Table 3-1 Installing the Cisco Unified IP Phone 6921, 6941, and 6961
Task Purpose
Connect the handset to the Handset port.
1.
Connect a headset to the Headset port.
2.
Optional. You can add a headset later if you do not
connect one now.
Optional. Connect the power supply to the Cisco DC
3.
Adapter port.
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP)
OL-23769-01
shows the connections for Cisco Unified IP phones 6921 and 6941,
"Using External Devices" section on page 3-4
Installing the Cisco Unified IP Phone
Figure 3-2 shows the connections for a Cisco
Table
Related Topics
—
See the "Headset" section on page 3-3
headsets.
See the "Adding Phones to the Cisco Unified CM
Database" section on page 2-8
Figure 3-3 shows the
for safety and
3-1.
for supported
for guidelines.
3-5