Skoda CAR RADIO RHAPSODY - FOR SUPERB 08-2003 Manual page 9

CONTROLS AND EQUIPMENT
Set-up Menu
If the SCAN knob 10 is pressed for longer than
2 seconds, specific settings can be made via the
display and the SCAN knob.
The following set-up menu points can be selected
by turning the SCAN knob:
l TIM Time 1
l TIM Time 2
l CLOCK
l GALA
l ON Volume
l PHONE
l RDS Name
l Exit
Settings can be made for the selected menu point
by briefly pressing the SCAN knob.
Your alterations will be stored and you will exit
from the set-up menu if you then press the SCAN
knob for longer than 2 seconds or select the menu
option „Exit".
If no changes are made for 15 seconds, you will
automatically exit from the set-up menu and the
alterations will not be stored. The exit from the
set-up menu will be indicated with a signal.
8
TIM Time 1 and TIM Time 2
Using the set-up menu points TIM Time 1 and
TIM Time 2 it is possible, when the vehicle is not
moving, to enter two different recording times for
traffic announcements with a total length of 4
minutes - please also refer to page 12.
Example:
You travel every working day at 8.00 a.m. to work
and come home at 5.00 p.m.
You enter 8.00 a.m. in the set-up menu point TIM
Time 1. All traffic announcements made by the
programmed TP station between 6.30 a.m. and
8.30 a.m. will be stored.
Enter 5.00 p.m. in the set-up menu point TIM
Time 2. All traffic announcements made by the
programmed TP station between 3.30 p.m. and
5.30 p.m. will be stored.
Setting the recording times
l Select the function „TIM Time 1" (This de-
scription also applies for TIM Time 2).
l Select „ON" and briefly press the SCAN
knob.
l „Set Hours" appears in the display. Set the
hour using the SCAN knob.
l Press the SCAN knob. „Set Minutes" appears
in the display. Set the minutes using the SCAN
knob.
l Press the SCAN knob to store the setting and
to exit the menu.
Switching off TIM Time
l Select the function „TIM Time 1" (This de-
scription also applies to TIM Time 2).
l Select „OFF" and briefly press the SCAN
knob.
CLOCK
The time can be set either manually or automati-
cally via the RDS signal. The time is only shown
in the CLOCK set-up menu point.
l Select in the menu: CLOCK. „Clock" is displa-
yed and the function currently selected.
l Briefly press the SCAN knob 10 and choose
whether you want to set the clock either ma-
nually or automatically by turning the SCAN
knob.
Setting the clock automatically
l Select the function „Automatic".
l Briefly press the SCAN knob. The time is set
automatically via the RDS signal.
Setting the clock manually
l Select the function „Manual".
l „Set Hours" appears in the display. Use the
SCAN knob to set the time.
l Briefly press the SCAN knob. „Set Minutes"
appears in the display. Use the SCAN knob
to set the minutes.
l Press the SCAN knob to store the settings and
to exit the menu.