Tp Button - Skoda CAR RADIO RHAPSODY - FOR SUPERB 08-2003 Manual

3 - TP button

Using the Traffic Program button you can control
traffic program functions (traffic information).
The TP function is switched on or off by pressing
the TP button. At the same time , a TA ready
mode (Traffic Announcement) is set up.
„TP" will appear in the display when the TP func-
tion is switched on (e.g. „TP: ANTENNE").
„TP: No TP" will appear in the display if a TP sta-
tion cannot be found.
If the current station is not a TP station, the radio
automatically selects the last TP station listened
to (Last Station Memory).
If this station is cannot be received, the radio will
automatically search for the next TP station with
a strong signal. „TP: TP-SeeK" appears in the
display. The letters „TP" appear in the display as
confirmation that a TP station is being received
(e.g. „TP: ANTENNE").
The frequencies and names of stations broad-
casting traffic news announcements are frequently
posted along motorways and trunk roads.
It is possible to store 6 traffic information stations
in the TP mode.
Changing TP station
Using traffic radio rocker switch 7, TP stations in
the memory levels (e.g. FM1) can be selected.
Press the right side of the rocker switch to select
the next TP station.
Press the left side of the switch to select the
previous TP station.
Auto-TP
The function Auto TP is used to automatically
select the TP station with the strongest signal.
Press the traffic radio rocker switch 7 until „TP:
auto TP" appears in the display. Release the
rocker switch.
A signal can be heard after approximately 5 sec-
onds and „TP: auto TP" flashes. The radio will
look for the TP station with the strongest signal
and will display it.
CONTROLS AND EQUIPMENT
TA ready mode
The TA ready mode makes it possible to listen
to traffic information reports. These reports will
be played at the programmed volume, even
when the volume is set at „very quiet" or another
source (AM, CD) is being used. If the range of
the set traffic information station is left, the sta-
tion search function will start after approximately
30 seconds.
The system will automatically switch to mono
whilst in TA ready mode and the DSP menu
„TALK" is activated for the duration of the an-
nouncement - see page 19.
Interrupting a traffic news announcement
In some situations it can occur that a traffic news
announcement is interrupted, e.g.:
- The announcement does not apply to this
stretch of road.
- The announcement is very long and the part
concerning this stretch of road is complete.
Press the TP button during the announcement
which is to be interrupted.
The announcement is interrupted and the pre-
vious operating mode - CD or radio - is resumed.
The traffic announcement is recorded in the TIM
memory and can be heard later. New traffic news
announcements will still interrupt the source be-
ing heard.
To turn the function off permanently press and
hold the TP button 3 until „TP: OFF" appears in
the display.
7