Using The Midi Terminals - Yamaha Clavinova CVP-203 Owner's Manual

Using the TO HOST terminal
Connect the serial port of the personal computer (RS-
232C terminal or RS-422 terminal) to the TO HOST
terminal of the CVP-205/203. For the connection cable,
use the appropriate cable below (sold separately) that
matches the personal computer type.
If your system does not work properly with the connections and
settings listed above, your software may require different settings.
Check your software operation manual and set the HOST SELECT
switch to the proper data transfer rate. (Data transfer rate of "PC-1"
is 31,250 bps.)
I IBM-PC/AT (Windows)
Connect the RS-232C terminal on the computer to the
TO HOST terminal on the CVP-205/203 using a serial
¡
cable (D-SUB 9P MINI DIN 8P cross cable). Set the
CVP-205/203 HOST SELECT switch to the "PC-2."
(Data transfer rate is 38,400 bps.)
Clavinova
MINI DIN
CVP-205
MINI DIN
PC-2 PC-1
MIDI Mac
* When using a D-SUB 25P
¡ MINI DIN 8P cross
cable, connect using a D-
CVP-203
SUB9P plug adaptor on
the computer side of the
Mac MIDI
cable.
PC-1 PC-2
I Macintosh
Connect RS-422 terminal (modem or printer) on the
computer to the TO HOST terminal on the CVP-205/
203 using a serial cable (system peripheral cable, 8
bit). Set the CVP-205/203 HOST SELECT switch to the
"MAC" (Data transfer rate is 31,250 bps).
Set the MIDI interface clock in the sequencer you are
using to 1 MHz. For details, refer to the owner's
manual for the particular software you are using.
Clavinova
MINI DIN
CVP-205 CVP-203
PC-2 PC-1
MIDI Mac
Mac
PC-1 PC-2
NEC MultiSync
PC-9821 A S
D-sub
8-pin 9-pin
D-sub D-sub
8-pin 25-pin 9-pin
MINI DIN
8-pin 8-pin
MIDI
Using Your Clavinova with Other Devices

Using the MIDI terminals

When using a MIDI interface device installed in the
personal computer, connect the MIDI terminals of the
personal computer and the CVP-205/203 with standard
MIDI cables.
• When the computer has a MIDI interface installed,
connect the MIDI OUT terminal of the personal
computer to the MIDI IN terminal. Set the HOST
SELECT switch to "MIDI."
Clavinova
CVP-205 CVP-203
PC-2 PC-1
MIDI Mac
Mac
• When using a MIDI interface with a Macintosh series
computer, connect the RS-422 terminal of the
computer (modem or printer terminal) to the MIDI
interface, then connect the MIDI OUT terminal on the
MIDI interface to the MIDI IN terminal of the CVP-
NEC
205/203, as shown in the diagram below.
Set the HOST SELECT switch to "MIDI."
Clavinova
CVP-205 CVP-203
PC-2 PC-1
MIDI Mac
Mac
• When the HOST SELECT switch is set to "MIDI," the
TO HOST terminal is disabled.
• When using a Macintosh series computer, set the
MIDI interface clock setting in the application
software to match the setting of the MIDI interface
you are using. For details, refer to the owner's
manual for the particular software you are using.
MIDI IN MIDI OUT
MIDI OUT MIDI IN
MIDI
PC-1 PC-2
MIDI IN
RS422
MIDI OUT
MINI DIN
8-pin
MIDI
PC-1 PC-2
CVP-205/203
NEC MultiSync
A
PC-9821 S
NEC
147