Choose Attachment Option - Whirlpool Gold GU3200XTXY Installation Instructions Manual

Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed
(you will need to measure the lowest point on the
underside of the countertop and the highest point on the
floor). Refer to "Dishwasher Height Adjustment Chart"
for wheel position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet Wheel
opening height position
Removed
34" (86.4 cm)
(87.0 cm)
NOTE: If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 33 " (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 34 " [87.6 cm].)
2 Adjust wheels and legs
Turn both leveler legs to the same height. Put wheels in
the required position determined from "Dishwasher
Height Adjustment Chart."
3
Built-up Floors—Add
shims as needed
2
"
( 5
c m
)
Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed in the area shown to bring the dishwasher up to
34 " (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
14
Number of turns
on front leg
All the way up
1 10
2 5
3 0
wheel

Choose Attachment Option

Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using 2 or more people, stand the dishwasher up.
Option 1, Countertop attachment:
1
Remove bracket
Remove the brackets from the package and place in the
open slots on the left and right-hand top of the
dishwasher collar as shown.
2
Insert bracket
1
2
3
Insert the bracket into the slot on the collar. Using a pair
of pliers, bend the tab down to secure the bracket in
place. Repeat this step for the other side.
NOTE: Do not attach the dishwasher. This will be done
later.
Option 2, Dishwasher side attachment:
NOTE: Remove the brackets from the parts package.
1
Break end of bracket
Break off the end of the bracket along the scored line.
With another person holding the rear of the dishwasher
to keep it from tipping, open dishwasher door and place
towel over pump assembly and spray arm of dishwasher.
This will keep screws from falling into pump area when
you are securing dishwasher to cabinet.
Excessive Weight Hazard
Tabs must point
to the right
score line