Thermostats - Vulcan-Hart VSX3E Service Manual

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS
2. Remove the screws at the bottom of panel.
3. Remove the lower access panels on the right
and left side of the unit to gain access to the
lower compartment.
4. Remove the screws Inside the lower
compartment that run along the top rear of the
base frame that secure the lip of the rear panel.
NOTE: Rear panel lip is "sandwiched" between the
base frame and the top lip of the small rear access
panel.
5. Pull the combination left side and rear panel off.
6. Reverse procedure to install.

THERMOSTATS

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Turn "off" the water supply and allow hot parts to
cool down if necessary.
2. Remove the right side panel as outlined under
"COVERS AND PANELS".
3. Manually drain the steam generator tank if
necessary, as outlined in "DRAIN TANK
MANUALLY".
4. Disconnect the lead wires from thermostat being
replaced.
5. Remove screws that secure the thermostat.
6. If replacing the control thermostat, fully loosen
the compression nut, sliding it away from tank,
then remove the bulb.
NOTE: When installing, do not over tighten as
thermostat calibration and/or damage to thermostat
may occur.
Page 7 of 40