Delta 50-775 Instruction Manual page 5

ASSEMBLING WHEEL
CASTERS
1. Remove the hex nut and lockwasher from each of
the four wheel casters.
2. Place the dust collector on its side.
2. Insert bolt from wheel caster through the four holes
(A) Fig. 3 in the base of the dust collector (three are not
shown).
3. Place a lockwasher (A) Fig. 4 onto each bolt.
4. Thread hex nut (B) Fig. 4 onto each of the four bolts
and tighten securely.
ASSEMBLING SIDE
SUPPORTS
1. Place the dust collector base (A) Fig. 5, in an upright
position as shown.
2. Align the two holes in the bottom of side support (B)
Fig. 5 with the two holes (A) in the base.
3. Insert a 5/16-18x3/4" hex head screw (A) Fig. 6 thru
each hole in the side support and base.
4. Place a 5/16" lockwasher onto the hex head screw.
5. Thread a 5/16" hex nut onto the hex head screw and
tighten securely.
6. Repeat this process for the remaining side support.
7. Fig. 7 shows both side supports (A) attached to the
base (B).
ASSEMBLY
A
Fig. 6
B
A
B
5
A
Fig. 3
B
A
Fig. 4
A
Fig. 5
A
Fig. 7