Tilting The Table; Adjusting The Table - Delta 16 SM600 Instruction Manual

TILTING THE TABLE

The table on your scroll saw can be tilted 45 degrees to
the left for bevel cutting operations by loosening table
lock handle (A) Fig. 30, tilt the table to the desired angle
and tighten lock handle (A).
When bevel cutting, the holddown (B) Fig. 31, can be
adjusted to lay flat on the stock by loosening screw (C)
and tilting the holddown (B) accordingly. Then tighten
screw (C).

ADJUSTING THE TABLE

1. Loosen the table locking handle, and move the table
all the way to the right.
2. Using a square (A) Fig. 32, check to see if the table
is 90 degrees to the saw blade, as shown.
3. If the table is not at 90 degrees to the blade, adjust
the table accordingly making certain screw (B) Fig. 33,
contacts bottom of table surface when table is 90
degrees to the blade. Screw (B) can be adjusted by
loosening nut (C), thread screw (B) in or out the desired
distance and tighten nut (C).
C
14
A
Fig. 30
B
Fig. 31
A
Fig. 32
B
C
Fig. 33