Breville INSTANT CAPPUCCINO CM8 Instructions For Use Manual page 2

Breville IC Instructions 13/11/06
9
8
7
5
6
13
4
1. Instant coffee chamber lid 6. Red ready indicator (around button)
2. Control dial 7. Blue power on indicator
3. Cleaning tray 8. Cup storage
4. Removable drip tray and cover 9. Water tank cap
5. Power on/off button 10. Milk tank
IMPORTANT POINTS TO REMEMBER
• Do not open the water tank cap when the machine is switched on. Instant Cappuccino uses a
pressurised boiler to make drinks. Hot steam, which can cause burns, will be released if the
water cap is opened.
• If you need to open the cap when the machine is hot, please follow the Steam Release
Procedure on page 9.
• Instant Cappuccino uses milk to make drinks, it is therefore important to clean after use. Milk left
in the unit will harden and clog the machine.
• The Instant Cappuccino is fitted with a safety device, which will turn the machine off if it is left
switched on for more than 2 hours.
• Always return the dial control to the STOP position when finished making cappuccino.
4:29 pm Page 3
FEATURES
1 10
CLEANING TRAY
11
3
STOP
2
COFFEE
CLEAN/GO
15 SHOT
12
14
CLEANING TRAY
11. Cleaning jug
12. Coffee dispenser
13. Dispensing nozzle
14. Milk pipe
15. Coffee chamber
2
BEFORE USING THE INSTANT CAPPUCCINO
INTRODUCTION
1. Remove the Instant Cappuccino carefully from the box. You may wish to store the packaging for
future use.
2. Check the contents:
• Instant Cappuccino maker
• Milk tank
• Cleaning jug
3. Position the Instant Cappuccino on a stable flat surface, close to a mains power socket and out
of the reach of children. The Instant Cappuccino produces steam, so avoid areas under
cupboards or other furniture/decorations that may be damaged.
INITIAL CLEANING
To ensure that residue left by the manufacturing process is removed, flush the machine with clean
water as described in the following procedure:
1. Wash the milk tank in warm soapy water,
rinse and dry.
2. Lift the coffee chamber lid and remove the
coffee dispenser, wash all parts in warm
soapy water, rinse and dry.
3. Reassemble the coffee dispenser, following
the diagrams and place back into
the machine. (figure A)
4. Remove the water tank cap and using the
measuring guide on the cleaning jug,
pour 300ml of clean water into the water
tank. (figure B)
A
5. Replace and tighten the water tank cap.
6. Ensure that the control dial is in the
STOP position
7. Fill the milk tank with clean water up to the
8 cup mark and place on the unit. Ensure
that the tank is pushed fully back on the
unit. (figure C)
C
B
3