Rear Panel Connections - McIntosh 60TH ANNIVERSARY SYSTEM - annexe 1 Owner's Manual

OUTPUTS 1 (Balanced) send
signals to a Power Amplifier
and is controlled by the C22
Front Panel OUT 1 Switch
Connect the C22 power cord
to a live AC outlet. Refer
to information on the back
panel of your C22 to deter-
mine the correct voltage for
your unit
OUTPUTS 1 and 2 send
signals to Power Amplifi-
ers and are switched On/
Off with the Front Panel
OUT 1 and 2 Switches
Main Fuse holder, refer
to information on the
back panel of your C22 to
determine the correct fuse
size and rating
OUTput 1 and OUTput 2 send
Turn-On signals to McIntosh
components and are controlled
by the C22 Front Panel OUT 1
and OUT 2 Switches
MAIN POWER CONTROL
Output sends a turn-on
signal to a McIntosh Com-
ponent when the C22 is
turned on
EXT SENSOR connector
permits the connection of
a McIntosh IR Sensor for
remote operation
RECORD OUT
sends signals to
the input of a
recording device
DATA PORTS send signals to
McIntosh Source Components
to allow control with the C22
Remote Control
SUM DATA PORT
sends data signals
from all the Data
Ports to McIntosh
Components for
control
RECORD, AUX, DVD, D/A,
CD, and TUNER, INPUTS
accept high level program
source signals

Rear Panel Connections

GND terminals accept
a ground wire from a
turntable
D/A and CD INPUTS
(Balanced) accept high
level program source
signals
PHONO MM accepts
signals from a Moving
Magnet phono cartridge
PHONO MC accepts
signals from a Moving
Coil phono cartridge
7