McIntosh 60TH ANNIVERSARY SYSTEM - annexe 1 Owner's Manual page 12

How to Operate, con't
Magnet (MM). The resistive load for the MC Input
is selectable from 10 ohms to 1,000 ohms. The ca-
pacitive load for the MM Input is selectable from 50
picofarads to 350 picofarads.
Select the Phono Load setting using the Front Panel
MC or MM Control for the cartridge type connected
to the C22. Choose the value closest to the recom-
mended load value specified by the Phono Cartridge
Manufacturer.
Headphones Jack
Connect a pair of dynamic headphones with a 1/4"
(6.3mm) stereo phone type plug to the Headphones
Jack for private listening.
How To Make A Recording
1. Use the Input Selector to choose the desired Source
Input Signal you wish to record. Refer to figure 2.
2. Adjust the record level using the recorder volume
control and proceed with the recording process.
12
3. To listen to the playback of the program source just
recorded, place the RECORD switch on the front
panel to the MONITOR position. The Front Panel
INPUT SELECTOR LED will flash indicating the
Input Source selected for recording. During the
time the RECORD Switch is in the MONITOR po-
sition Source Selection is not possible, either by us-
ing the Front Panel INPUT SELECTOR or Remote
Control INPUT Upp or Downq push-buttons.
Refer to figures 2 and 3.
Note: The C22 RECORD OUTPUT Signals are not
affected by the setting of VOLUME or BALANCE
Controls.
Reset of Microprocessors
In the unlikely event the controls of the C22 stop func-
tioning, the microprocessors can be reset by placing
the Front Panel POWER Switch in the STANDBY/ON
position and holding it in for fifteen seconds and then
releasing the switch.
Figure 2
How to Operate, con't
POWER
INPUT
VOL INPUT
VOL
PLAY
STOP
NEXT
BACK
PAUSE
Figure 3