Summary of Contents for McIntosh 60TH ANNIVERSARY SYSTEM - annexe 1
Page 1
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 www.mcintoshlabs.com Anniversary Stereophonic Preamplifier Owner’s Manual...
The lightning flash with arrowhead, within an equilateral The exclamation point within an equilateral triangle is triangle, is intended to alert the user to the presence of intended to alert the user to the presence of important uninsulated “dangerous voltage” within the product’s en- operating and maintenance (servicing) instructions in the closure that may be of sufficient magnitude to constitute literature accompanying the appliance.
Customer Service General Information Your decision to own this McIntosh C22 Stereophonic If it is determined that your McIntosh product is in 1. The C22 uses Vacuum Tubes for amplifying the Preamplifier ranks you at the very top among discrim- need of repair, you can return it to your Dealer.
Amplifiers. The C22 reproduction is sonically trans- Front panel Output Push-buttons control two Switched PIN 2: + Signal parent and absolutely accurate. The McIntosh Sound is Outputs that allow sending signals to two separate PIN 3: - Signal “The Sound of the Music Itself.”...
Dimensions Dimensions The following dimensions can assist in determining the best location for your C22. Front View of the C22 " 44.45cm " 6" 13.69cm 15.24cm Side View of the C22 " 40.32cm " " -1/2 36.83cm 1.59cm " 13/16 "...
Installation Installation The C22 can be placed upright on a table or shelf, " 1/16 43.34cm standing on its four feet. It also can be custom in- stalled in a piece of furniture or cabinet of your choice. The four feet may be removed from the bottom Opening for Ventilation of the C22 when it is custom installed as outlined be- low.
AC outlet. Refer Output sends a turn-on sends data signals (Balanced) accept high to information on the back signal to a McIntosh Com- from all the Data level program source panel of your C22 to deter- ponent when the C22 is...
19. Connect Balanced Cables from the C22 OUTPUTS using the C22 Remote Control. With an external sen- 8. Connect any additional McIntosh Components in a 1 L and R Jacks to the Power Amplifiers (Main sor connected to the C22, remote control operation of similar manner, as outlined in steps 1 thru 4.
How to use the Remote Control How to use the Remote Control The supplied Remote Control is capable of directly controlling the functions of contemporary McIntosh Source Components connected to the C22 Tube Pre- Press to Power the amplifier. C22 ON or OFF...
Front Panel Displays, Controls, Switches and Jack BALANCE Control Indicates when the VOLUME Control allows the adjustment C22 is connected to adjusts the listening level of the relative volume an active AC Outlet for both channels balance between chan- nels INPUT SELECTOR Control MODE SELECTOR allows IR Sensor receives...
How to Operate How to Operate Power On in each Loudspeaker. Rotate the BALANCE counter- phasize the high frequency content The Red LED located under the “1949-2009” nomen- clockwise to emphasize the Left Channel by reducing of the music. clature on the Front Panel lights to indicate the C22 is the level of the Right Channel.
Page 12
How to Operate, con’t How to Operate, con’t Magnet (MM). The resistive load for the MC Input 3. To listen to the playback of the program source just is selectable from 10 ohms to 1,000 ohms. The ca- recorded, place the RECORD switch on the front pacitive load for the MM Input is selectable from 50 panel to the MONITOR position.
Specifications Specifications Frequency Response Voltage Gain Overall Dimensions +0, -0.5dB from 20Hz to 20,000Hz High Level to Record Output: 0dB Width is 17-1/2 inches (44.45cm) +0, -1dB from 10Hz to 100,000Hz High Level to Output 1 and 2: 15dB Height is 6 inches (15.24cm) including feet Phono MM to Record Output: 40dB Depth is 18 inches (45.72cm) including the Front Total Harmonic Distortion...
017937 Plastic foot needed, please call or write Customer Service Depart- 400159 #10-32 x 3/4” screw ment of McIntosh Laboratory. Refer to page 4. Please 404080 #10 Flat washer see the Part List for the correct part numbers. FOAM PLUG...
Page 16
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, NY 13903 www.mcintoshlabs.com The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserve the right to improve design without notice. Printed in the U.S.A. McIntosh Part No. 04112100...