Related Manuals for NAIM CDX2 - CD5
Summary of Contents for NAIM CDX2 - CD5
- Page 1 W O R L D C L A S S H I F I O W N E R S M A N U A L I S S U E 1 CD Players: CDX2, CD5...
-
Page 2: Table Of Contents
1 Equipment Installation 3.5 if you have a problem Normally your Naim equipment will have been installed by the dealer who sold it to you 4 Warnings even if you live outside their immediate vicinity. Your dealer is responsible for making... -
Page 3: Mains Supply
In most territories a dealer must be prepared to take back improve system performance. any Naim equipment he has sold you if he cannot make it work to your satisfaction in your own home. A problem may Do not wire voltage dependent resistors or noise be due to a fault in any part of the system or its suppressors into mains plugs. -
Page 4: Connection
Use of non-standard speaker cables or interconnects may correct replacement must be obtained from your dealer, or invalidate your guarantee. from Naim Audio direct. Do not use the plug until the fuse carrier is replaced. 5.4 plug fuses Replace only with ASTA or BS 1362 approved fuses. - Page 5 CDX2 case should be removed before use and must be replaced if the unit is to be re-packed and shipped. This transit screw must not be used in any other Naim product. The transit screw location is illustrated in Diagram 10.1. Do not invert the player once the transit screw is removed.
- Page 6 CDX2 7.1 CDX2 Rear power mains optional RC5 input link plug fitted alternative to preamplifier input RCA phono RS232 data port output sockets Note CDX2 Output The RC5 input fitted to the CDX2 is intended to accept external control signals for multi-room applications. Contact your dealer for further information on their use.
-
Page 7: Power Supply
CD5 case should be removed before use and must be replaced if the unit is to be re-packed and shipped. This transit screw must not be used in any other Naim product. The transit screw location is illustrated in Diagram 10.1. Do not invert the player once the transit screw is removed. - Page 8 9.1 CD5 Rear link plug fitted to preamplifier power mains input RC5 input CD5 Output Note The RC5 input fitted to the CD5 is intended to accept external control signals for multi-room applications. Contact your dealer for further ch 2 information on its use.
-
Page 9: 10 Cdx2/Cd5 Operatation
CDX2/CD5 Operation 10.1 Transit Screw Remove the transit screw (keep safe). Always replace this before transit or shipping. 10.2 CD Loading Open the drawer. - Page 10 CDX2/CD5 Operation Place the compact disc on the platter. Make sure it is seated properly. Place the puck on the compact disc. Close the drawer.
- Page 11 Flash Handset 11.1 Introduction selected page is shown in the top right corner of the Flash is factory pre-programmed to operate any Naim display. Details of the master key functions within each preamplifier or cd player, the NAT 05 tuner and AV2 page is described in the following paragraphs: audio-visual processor.
- Page 12 Flash Handset 11.3 cd track programming TUN (tuner mode) Page 1 of 1 mode the prog key (display Page Two) enables Depending on the operational mode selected, specific CD tracks and their play order to be programmed. adjusts the tuning frequency upwards To program a play order select a track number from the (frequency mode), searches for stations up...
-
Page 13: 12 Narcom 3 Handset
Balance Narcom 3 is a multi-functional remote control handset centring is indicated by a flashing volume designed to be used with Naim Audio CD players, control indicator. To resume adjustment once integrated amplifiers, preamplifiers and preset tuners. - Page 14 —— or no display. indicates that Declaration of conformity to appropriate standards Manufacturer Naim Audio Limited, Southampton Road, Salisbury, England, SP1 2LN Products CDX2, XPS, CD5 Safety HD 195-S6 EN 60 065...
- Page 15 Part No. OWMCD 12-001-0041 Naim Audio Limited, Southampton Road, Salisbury, England SP1 2LN Telephone: +44 (0) 1722 332266 Fax: +44 (0) 1722 412034 www.naim-audio.com Drawing No. NA101003-400...