Safety Instructions - NAIM CD5 XS Manual

saFeTY InsTruCTIons

In order to comply with current european safety regulations
it is essential that the naim loudspeaker connectors
supplied with amplifiers and loudspeakers are used.
Do not under any circumstances allow anyone to modify
your naim equipment without first checking with the factory,
your retailer, or your distributor. unauthorised modifications
will invalidate your guarantee.
equipment must not be exposed to dripping or splashing
and no objects filled with liquid, such as vases, should be
placed on the equipment.
For your own safety do not under any circumstances open
naim equipment without first disconnecting it from the
mains.
warning: an apparatus with CLass I construction shall
be connected to a mains socket outlet with a protective
earthing connection.
where the mains plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable. To disconnect the equipment from the
mains remove the mains plug from the mains outlet.
The following label is attached to all mains powered
equipment:
w a r n I n G
noTe
This equipment has been tested and found to comply
with the relevant emC and safety standards, and, where
applicable, also complies with the limits for a class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult your Naim retailer or an experienced radio/TV
technician for help.
THIs aPParaTus
musT Be earTHeD
Con ten ts
Page section
e1 1 Connections
e1 2 mains Power
e2 3 General Installation
e3 4 CD 555 Introduction and Installation
e4 5 CD 555 Connections
e5 6 CD 555 In use
e6 7 CDs3 Introduction and Installation
e7 8 CDs3 Connections
e8 9 CDs3 In use
e9 10 CDX2 Introduction and Installation
e9 11 CDX2 Connections
e10 12 CDX2 In use
e11 13 CD5 Xs Introduction and Installation
e11 14 CD5 Xs Connections
e12 15 CD5 Xs In use
e13 16 CD5i Introduction and Installation
e13 17 CD5i Connections
e13 18 CD5i In use
e14 19 CD Player Control and operation
e15 20 r-com Handset
e16 21 narcom 4 Handset
e17 22 Puck Identification
e17 23 Declarations