NAIM CD5 - ISSUE 2 Manual page 6

CDS3
6.4 player display and indicators
The alphanumeric display indicates track and index numbers,
time in minutes and seconds, or various system messages
(Error, Track programming info, etc). The full stop on the right
of the display window illuminates when the player receives a
signal from the remote handset. If a track play list is
programmed the time displayed reflects the duration of the
program. Above the display are four indicators.
HDCD: Illuminates to show that an HDCD encoded disc
is playing.
time: Illuminates to indicate display of total disc time
or elapsed time of track being played.
repeat: Illuminates to show that repeat has been
selected from the remote handset.
prog: Illuminates to indicate that a program has been
stored. Further information on play list
programming can be found in Sections 15 and 16
6.5 output socket selection
A pair of phono output sockets are fitted at the rear of the
CDS3 to provide an alternative to the preferred DIN socket.
Proceed as follows to select the phono sockets.
With the player stopped, press and hold the remote
handset disp function (handset in CD mode) or front panel
disp button until the CD player prog indicator flashes.
Further operations of the disp
through each combination of the two socket types (DIN
only, phono only or both). The selected option is indicated
on the CD player display as shown below.
Socket Option
DIN
Phono
Both
Press and hold the disp function a second time to exit from
socket selection mode.
function will now cycle
Player Display
O
o 0
O
o 0
6.6 player maintenance
It is important for reliable operation of the CDS3 to ensure
that the surfaces of the transport platter and the underside
of the puck are free of dust or debris which can prevent
the disc from sitting properly and cause it to slip.
To clean the transport platter, take a piece of Blu-tack and
lightly apply it to the top surface of the magnetic metal
hub, picking up any material attached to it. Brush the
plastic outer edge lightly with your finger or a soft brush to
ensure that it is dust and particle free. Similarly, clean the
puck with Blu-tack, to remove debris from the three
locating pins on its underside. Take care not to damage the
rubber pressure pads. Brush them lightly with your finger or
a soft cloth.
Do not, under any circumstances, use any solvents or fluids
for the cleaning process.
5