Setting Auto-Start Time; Changing And Setting The Menu Parameters; Setting The Clock - DeLonghi EAM3400 Important Instructions Manual

Check that the two red buttons have snapped out, otherwise the door cannot be closed.
The two red buttons have
snapped out
CORRECTLY
NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snap-
ped out, the service door cannot be closed.
NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it force-
fully from the top and bottom simultaneously, as shown in figure 28.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the outlet then plug in again.
Wait for all the lights to go off, then open the door and replace the infuser.
• replace the drip tray, complete with the grounds container;
• close the service door.

12 CHANGING AND SETTING THE MENU PARAMETERS

The following menu parameters and functions can be changed by the user:
• Clock
• Auto-start time
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
• Water hardness
• Factory default values

12.1 Setting the clock

To set the clock, proceed as follows:
• Press the button (the light over the button comes on) then press the
the appliance displays
• Press the button to set the clock. (If you hold the
rapidly).
• Press the button to confirm the value;
• Press the button to exit programming mode or

12.2 Setting auto-start time

This programs the time the appliance will come on automatically.
• Make sure the clock on the appliance is set as described above.
• Press the button then press the
16
INCORRECT
CORRECT
CLOCK 00:00
button repeatedly until the appliance displays:
START TIME 00:00
The two red buttons have not
snapped out
button repeatedly until
, button down, the time is changed
to change other parameters.