Cleaning The Milk Container; Changing And Setting The Menu Parameters; Setting The Clock; Setting Auto-Start Time - DeLonghi Coffee Maker Instructions Manual

NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the mains, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door and
replace the infuser.

15.3 Cleaning the milk container

Proceed as follows:
• Remove the milk spout (fig. 32) and intake tube.
• Remove the froth regulator by pulling it outwards.

16 CHANGING AND SETTING THE MENU PARAMETERS

After pressing the
lowing parameters and functions:
• Clock
• Auto-start time.
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
• Water hardness
• Factory default values
• Washing process

16.1 Setting the clock

To set the clock, proceed as follows:
• Press the
the appliance displays:
• Press the
rapidly).
• Press the button to confirm the value;
• Press the button to exit programming mode or

16.2 Setting auto-start time

This enables the time the appliance will come on automatically and be ready for use to be programmed.
• Make sure the clock on the appliance is set as described above.
• Press the
froth
regulator
button, when the appliance is ready, you can use the internal menu to modify the fol-
button (the light over the button comes on) then press the
button to set the clock. (If you hold the
button then press the
• Wash the container and lid in a dishwasher or in
hot soapy water. Make sure there are no milk resi-
dues inside the two holes in the lid of the milk con-
tainer indicated by the arrows in the figure.
• Put the froth regulator, intake tube and milk spout
back in the milk container lid.
CLOCK 00:00
button repeatedly until the appliance displays:
START TIME 00:00
button repeatedly until
button down, the time is changed
to change other parameters.
33