Setting The Timer; Operating Your Coffee Maker; Preparing Coffee Maker For Brewing - DeLonghi DC54TC Series Instruction Manual

SETTING THE TIMER

1. To preset your coffee maker to brew at a later time first verify that the clock is
set to the correct time. (See "Setting the Clock" section of this manual for
details).
2. Press and hold PROG button. While continuing to hold the PROG button, press
the HOUR button until the desired brew time hour is reached. NOTE: Be sure
to check the AM / PM indicator, located on the left side of the digital clock
display. Then press the MIN button until the desired minutes have been
reached. Release the PROG button.
3. Follow the "Operating Your Coffee Maker" steps 1 through 10. Then, press the
ON-OFF / TIMER button only once, the TIMER light will illuminate. Your coffee
maker is now set to start brewing at the programmed time. When the ON / OFF
light illuminates, this indicates that your programmed brew time has now been
activated. NOTE: If you wish to deactivate the TIMER function, press the ON-
OFF / TIMER button repeatedly until the TIMER light is no longer illuminated.
4. NOTE: If you wish to use the AROMA function, press the AROMA button
immediately after TIMER light is illuminated. When the AROMA function is
activated, the indicator will illuminate. NOTE: If the ON-OFF/ TIMER button
is pressed before the PROG button, the TIMER function will not activate.

OPERATING YOUR COFFEE MAKER

PREPARING COFFEE MAKER FOR BREWING:

1. Place the coffee maker on a flat, level surface away from any edge.
2. Plug the unit into a 120V / 60Hz only outlet.
3. The lid of the carafe must be fitted properly during the brewing process. And
the carafe must be set on the warming plate.
4. The filter basket door must be properly closed
during the brewing process. CAUTION: If the filter
basket door is not completely closed, the Pause 'N
Serve feature will not function properly. It could
cause hot water or hot coffee to overflow.
FILLING THE WATER RESERVOIR: Figure 5
5. Open the hinged water reservoir cover located at the
top of the coffee maker. Fill the carafe with the desired amount of cold water.
Empty the water from the carafe into the water reservoir.
6. Close the hinged lid. Place the carafe with the lid in place on the warming plate.
(DC55TC Series Only)
-8-
FIGURE 5