Onkyo TX-NR818 Instruction Manual page 80

2
To select an input source for Zone 2/3, press ZONE
repeatedly, followed by an INPUT SELECTOR
button.
To select AM or FM, press the TUNER input selector
and ZONE repeatedly.
3 To turn off Zone 2/3, press ZONE repeatedly,
followed by RECEIVER.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Adjusting the Volume for Zones
■
Operating on the remote controller
1 Press ZONE repeatedly.
2
Use VOL / .
■
Operating on the AV receiver
1 Press ZONE 2 or ZONE 3 (the Z2/Z3 indicator on
the AV receiver's display flashes).
2 Use MASTER VOLUME control within 8 seconds.
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
Muting Zones
■
Operating on the remote controller
1 Press ZONE repeatedly, and then press MUTING.
Tip
• To unmute, press ZONE followed by MUTING again. Zones can
also be unmuted by adjusting the volume.
Note
• Only analog input sources are output by the ZONE 2/3 LINE
OUT and FRONT WIDE/ZONE 2 L/R, FRONT
HIGH/ZONE 3 L/R terminals. Digital input sources are not
output. If no sound is heard when an input source is selected,
verify that the source is connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2/3. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2/3.
• When you have selected NET or USB as input selector, the last
selector selected will be set for Main room and Zone 2/3.
• When Zone 2/3 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• While Zone 2/3 is on, functions will not work.
• When setting the AV receiver to standby mode while Zone 2/3 is
active, the Z2 or Z3 indicator is dimly lit.
• Activating Zones in the main room when the listening mode is set
to Pure Audio will automatically switch it to Direct.
• "GAME2" cannot be selected as input sources for Zone 2/3.
• When "GAME2" is the input source of Main room and Zone 2/3
is set to share the same source, no sound will be output from
Zone 2/3.
• Even if you repeatedly press the remote controller's ZONE to
select zones, the last zone selection will be retained once you
have switched to other components by pressing other REMOTE
MODE after pressing ZONE.
En-80
Advanced Operations