Communications - Dell OptiPlex 980 Technical Manualbook

Communications – Primary Integrated LAN
NOTE: The OptiPlex XE supports 2 on-board LOMs (LAN On Motherboard) standard
INTEGRATED BROADCOM® BCM5761 NETXTREME®
10/100/1000 GIGABIT ETHERNET (GBE)
External Connector Type
Data Rates supported
Controller Details
Controller bus architecture
Integrated memory
Data transfer mode (example Bus-Master DMA)
Power consumption (full operation per data rate connection
speed)
Power consumption (standby operation)
IEEE standards compliance (example 802.1P)
Hardware Certifications (example FCC, B, GS mark...)
Boot ROM Support
Network Transfer Mode (example Full Duplex, Half Duplex)
Network Transfer Rate (example 10BASE-T (half-duplex) 10 Mbps
10BASE-T (full-duplex) 20 Mbps
100BASE-TX (half-duplex) 100 Mbps
100BASE-TX (full-duplex) 200 Mbps
1000BASE-T (full-duplex) 2000 Mbps
Environmental
Operating temperature
Operating humidity
Operating System Driver Support
Manageability (examples WOL, PXE)
Management Capabilities Alerting
OptiPlex XE Technical Guidebook
DT
RJ45
10/100/1000 Mbps
PCIe 1.1 x1
48-KB rx and 8-KB tx buffer
DMA
1023mW (+5% for 1.2V and 2.5V, nominal
+10% for 3.3VMax.)
203mW (D3cold with WOL enabled.)
802.3
RoHS
SPI flash
10 Mb (full/half-duplex)
100 Mb (full/half-duplex)
1000 Mb (full-duplex)
0° C to 70° C (32° F to 158° F)
20% to 80% (non-condensing)
Windows® XP, Windows Vista® Ultimate,
Windows Vista® Business 32 bit/64 bit,
Windows Vista Home Basic
WOL, PXE 2.1
Broadcom® TruManage™
SFF
Page 22