b.
To insert the new battery, slide one edge of the replacement battery under the holder's lip with
the positive side up. Push the other edge down until the clamp snaps over the other edge of
the battery (2).
Figure 3-2
Type 3
a.
Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.
Insert the new battery and position the clip back into place.
Figure 3-3
8.
Replace the computer access panel.
ENWW
Removing and Replacing a Coin Cell Battery (Type 2)
Removing a Coin Cell Battery (Type 3)
NOTE
After the battery has been replaced, use the following steps to complete this
procedure.
19