Secure Manager Setup - Compaq 3000R - ProLiant - 128 MB RAM Installation Manual

Hewlett-packard va 7100/7400 microsoft cluster services installation guide for hp netservers

Hide thumbs Also See for 3000R - ProLiant - 128 MB RAM:

Table of Contents

4. Click on Device Settings and observe that the Device Settings window for the selected LUN is displayed as

shown below. On the display below, use the pull-down menu to select the desired Load Balancing Policy.

5. Repeat steps

6. AutoPath configuration is now complete.

Secure Manager Setup

To set up Secure Manager for Windows 2000, proceed as follows:

1. Ensure that Secure Manager for Windows 2000 software has been installed. Refer to the

and

Applicable Documents/Reference Material

NOTE

2. To enable Secure Manager, proceed as follows:

a. Open a DOS window, and type the following:

armfeature -a -f LUN_SECURITY_xxGB –k <LicenseKey> <SerialNUMBER>

b. To ensure that the Secure Manager feature has been installed, type the following:

Armfeature –r <serialnumber>

10/12/01

and

for each LUN that has been configured.

Secure Manager is not required if this cluster is the only host communicating with the virtual array.

If there are other hosts or clusters in the system, Secure Manager is required.

paragraphs of chapter 2.

VA 7100/7400 Cluster Installation Guide

Hardware Connections

Table of Contents