Automatic Installation - Using The Hp Navigator Cd; Manual Installation; Creating The Drivers Diskettes - Compaq 3000R - ProLiant - 128 MB RAM Notice

2. Manual Installation – do the following:
· Create the HP NetServer Windows 2000 drivers diskettes using the HP
NetServer Navigator CD-ROM.
· Select one of the following methods for installation:
- Create Windows 2000 Setup diskettes. Use those diskettes to begin the
installation. Insert and use the Windows 2000 CD when prompted. You may
need to use this method if you have an HP NetServer LX Pro (see
troubleshooting tip 5, later in this document).
Or
- Boot directly from the Windows 2000 CD to begin the installation.
(Supported on all HP NetServer systems except the LX Pro–see
troubleshooting tip 5, later in this document).
Automatic Installation – Using the HP Navigator CD
HP recommends that you follow this method to install Windows 2000. This is the easiest
method because it requires less user intervention. Following are the steps to complete the
installation of Windows 2000 using the HP Navigator CD.
1. Boot the system from the HP Navigator CD.
2. Select "Configure the Server" from the Navigator main menu.
3. At the next screen, select "Guided Setup".
4. Follow the on-screen prompts to complete the installation.

Manual Installation

Creating the Drivers Diskette
Before you begin, use one of the following two methods that can be used to create the
drivers diskette. One method is to create the drivers diskette using a system booted from
the Navigator CD. The other method is to create the drivers diskette using a system that
is running Windows NT, Windows 2000, or Windows 95/98.
Creating the Drivers Diskette at the server after booting from the Navigator CD
1. Boot the system from the Navigator CD.
2. Select "Diskette Library" from the Navigator main menu and follow the on-screen
instructions to create the desired diskette(s).