Compaq 226824-001 - ProLiant - ML750 User Manual page 98

6. Auto Boot - Let SMP boot the destination server—If the destination server is not booted to the SMP
Boot CD and the destination agent is not launched, select this option.
7. The Next and Previous buttons are disabled during the reboot. To view the booting process of the
destination server, click Launch iLO, and then open the remote console.
To cancel the boot process and power down the destination server, click Cancel Booting.
8. Test the network connections and latency between the source-to-destination server and the
application-station-to-destination server. The results of a 2-second test initially appear.
9. To perform additional tests, select a test time in the Test network connections section, and then click
Test. The following test times are available:
2 seconds
5 seconds
10 seconds
30 seconds
60 seconds
If the source-to-destination or application-station-to-destination connection cannot be established, the
Next button is disabled. Ensure that ports 51 125 and 51 126 are open between source and destination
servers.
If the source-to-destination or application-station-to-destination connection is established but the network
test reports a transfer speed below 250 kbps, the Next button is disabled.
If the source-to-destination or application-station-to-destination connection is established and the network
test reports a transfer speed of at least 250 kbps, the Next button is enabled.
CAUTION:
the migration. Latency exceeding 125 milliseconds during driver installation might cause the driver
installation to fail. Before continuing with the migration, verify the proper duplex setting, and then check
the latency again.
10. Click Next.
98 Using SMP for server migration
If the application-station-to-destination latency is less than 125 milliseconds, continue with