Dell Cluster Configuration Support Matrix - Dell POWEREDGE Cluster FE655WI Platform Manual

Table 1-3. iSCSI Switch-Attached Clusters Rules and Guidelines (continued)
Rule/Guideline
TOE NIC for iSCSI traffic Ethernet daughter card: Broadcom 5708 Gigabit dual-port NIC controller for PowerEdge
NIC driver version
SNP
Switch configuration for
iSCSI traffic
Switches for external
iSCSI network
Ethernet modules for
iSCSI traffic
AX150i core software
(FLARE)
CX3-10c, CX3-20c, and
CX3-40c core software
Obtaining More Information
For more information about iSCSI-based clusters, see Dell PowerEdge Cluster FE655Wi Systems
Installation and Troubleshooting Guide located on the Dell Support website at support.dell.com.

Dell Cluster Configuration Support Matrix

The Dell Cluster Configuration Support Matrix provides the latest supported drivers, firmware, and the
operating system versions for your PowerEdge cluster FE655Wi solution. To obtain the supported drivers
and the firmware version for the operating system that is running on your PowerEdge cluster FE655Wi
nodes:
1 Open a Web browser.
2 Navigate to the Dell High Availability Clustering website at www.dell.com/ha.
3 Click the Products & Services tab.
4 In the Product Offerings window, click FE655Wi.
The Dell Cluster Configuration Support Matrix appears.
5 Locate the appropriate drivers and firmware that are supported on your hardware and software
components and the operating system version.
10
Platform Guide
Description
1955 systems only.
See "Dell Cluster Configuration Support Matrix" on page 10 for the supported versions.
Microsoft SNP required to enable TOE capability on PowerEdge 1955 systems.
Dual switch fabrics are required.
Gigabit Ethernet switches are required.
• Two Gigabit Ethernet pass-through modules.
• Two PowerConnect 5316M Ethernet switch modules.
See "Dell Cluster Configuration Support Matrix" on page 10 for the supported versions.
See "Dell Cluster Configuration Support Matrix" on page 10 for the supported versions.