Print And Check The Network Setup Page - Dell 1700/1700n Owner's Manual

Plug one end of the printer power cord into the socket at the back of the printer and
3
the other end into a properly grounded outlet.
Turn on the printer.
4
After the printer completes its internal tests, the Ready/Data light comes on.
If the operator panel lights do not come on when the printer is turned on, make sure
the power cord is firmly plugged in at the back of the printer and at the electrical
outlet.
If the printer is on but nothing prints, or if print jobs are not printing and the Error
light is on solid, make sure the toner cartridge is installed.

Print and Check the Network Setup Page

When the Ready/Data light is on solid, press and release Continue to print a menu
1
settings page and a network setup page.
Under the Standard Network Card heading on the network setup page, make sure
2
Status is Connected.
If Status is Not Connected:
– Make sure the Ethernet cable is firmly plugged into the back of the printer.
– Plug the Ethernet cable into another wall outlet.
Under the "TCP/IP" heading on the network setup page, make sure the IP address,
3
netmask, and gateway are what you expected.
S e tt i n g Up fo r N et wo r k Pri nti ng
39